الوصف
جهد التشغيل 4-30 V DC
كارته التحكم في سرعه موتور استبرر- stepper motor
The single PWM generator has only one set of PWM1 outputs, and the frequency and duty cycle are independently adjustable.
The dual complementary PWM has two sets of PWM1 and PWM2 outputs, the two sets of frequencies are the same, and the duty cycles are complementary.
Adjustable frequency 1-160KHz
Duty cycle 0-100% adjustable
Working voltage: 4V~30V
Frequency range: 1Hz~160KHz
Frequency accuracy: 2%
Signal load capacity: output current 5~30mA
Output amplitude: The amplitude is equal to the operating voltage.
PWM output, can set frequency, duty cycle separately
The frequency is divided into four ranges and is automatically switched:
1. XXX (no decimal point): value 1Hz~999Hz, unit 1Hz
2. X. XX (the decimal point is in the hundred digits): the value is 1.00KHz~9.99KHz, the unit is 0.01KHz
3. XX. X (decimal point is ten): value 10.0KHz~99.9KHz, unit 0.1KHz
4. X. X. X. (full decimal point): value 100KHz~160KHz, unit 1KHz
E. g:
100 means 100Hz
1.00 means 1.00KHz
10.0 means 10KHz
1.0. 0. indicates 100Khz
Duty cycle 0~100% adjustable
Setup process:
1. Press the SET button, the frequency parameter flashes, and the frequency is set by the UP or DOWN button.
2. Press the SET button, the duty cycle parameter flashes, and the duty cycle is set by the UP or DOWN button.
3. Press the SET button to exit the setting.
4. Press and hold the UP button and DOWN button to increase or decrease quickly.
5. Data is automatically remembered, and all setting parameters are saved after power down.
Use:
1. Used as a square wave signal generator to generate a square wave signal for development and use.
2. Used to generate a square wave signal that drives the stepper motor driver.
3. Generate adjustable pulses for use by the MCU.
4 Generate adjustable pulses to control the associated circuitry.